Ultimate Support Systems IQ-200 产品宣传页

STEP 1

STEP 1

STEP 2

STEP 3

STEP 3

STEP 5

STEP 5

STEP 7

Remove rubber sleeves from back side of the 

two top tubes of the IQ-1000 or IQ-2000.

Slide on Small Friction Sleeve to desired 

position. Leave at lest 1.25” clearance from the 

end of the tube for the 2nd Tier Assembly.

A.  (2) Tier Assemblies
B.  (2) Small Friction Sleeves
C.  (2) Z-nobs
D.  (2) Washers
E.  (2) Hex Nuts

Make sure the plastic red triangle is at the joint. 

This helps keep the joint open for sliding the 2nd 

Tier Assembly into place.

Loosen z-knob until resistance is gone. You do 

not have to completely unscrew for hex nut to 

adjust second tier. 

Pull tier to the outside of the IQ-1000  

or IQ-2000.

Fold stand into closed position and push 2nd tiers in. Tighten  

2nd tier z-knobs.

While holding the plastic red triangle, slide the 

2nd tier into the top tube.

Remove the plastic red triangle when Tier 

Assembly is fully in.

Install hand z-knob, washer, and hex nut. It  

is important to place the hand knob on the 

inside or stand will not fold fully. Also, be  

careful not to over-tighten the hand knobs 

because over-tightening may case cracking  

of the collar. 

Repeat steps 1-7 with other 2nd Tier Assembly.

In preparation for STEP 3, use water and soap to 

lubricate tube.

A.

B.

C.

D.

E.

(Continued)

STEP 8

Z-nobs, washer, and hex nuts are assembled together. Remove 
hex nuts when adding to tier assemblies.

STEP 2

STEP 4

Plastic red  

triangle