Desa (V)KC42P 用户手册

下载
页码 40
www.desatech.com
116239-01A
22
Lock
Unlock
Glass Frame
Assembly
Screw
Figure 42 - Removing/Replacing Glass Door
Hinge
Removing Glass Door
If replacement of glass is necessary, the entire assembly, glass and 
frame, must be replaced. If glass is broken, wear gloves and tape 
the remaining fragments onto the frame. 
1.  Remove screen assembly by pushing the rod either left or right 
and then down and forward to remove screen/rod assembly 
from the firebox. Set assembly aside.
2.  Lift up on latches to unlock. There are two on top of firebox and 
two below firebox that hold glass door in place (see Figure 42).
3.  While holding glass door to prevent it from falling and causing 
injury, remove the five screws from the hinge located on the 
left side of door frame assembly (see Figure 42). 
4.  Remount the new frame at the hinge with five new screws 
before closing door. This will ensure seating of the gasket. 
5.  Close glass door frame. Lock latches by placing the bar under the 
tab on door and pushing down and back on latch (see Figure 42).
6.  Replace screen/rod assembly by reversing step 1.
7.  Replace  louvers  by  reversing  procedure  under  Removing 
Louver Panels, page 21.
Latch
FIREPLACE INSTALLATION
Continued
FIREPLACE INSTALLATION
Removing/Replacing Glass Door (Cont.)
Installing Lava Rock and Glowing Embers
Cleaning Glass Door
See Cleaning and Maintenance on page 27.
INSTALLING LAVA ROCK AND GLOWING 
EMBERS
It is very important to keep logs exactly as installed. Do not modify 
logs. Only use log set designed for this fireplace. 
 WARNING: Logs are unitized but not attached to 
the burner. Do not handle log assembly by top logs. 
Always pick up by the bottom.
Open louvers, remove screen, unlock door latches and open glass 
door. See Removing Glass Door, steps 1 and 2. 
1.  Pull ember material apart into pieces no larger than a dime. Place 
these pieces loosely and sparingly directly onto the exposed front 
section of the burner (see Figure 43). This will create the glow-
ing ember appearance as the flame touches the ember material. 
Do not block air slots by using too much ember material in 
one area. It is not necessary to use all of the ember material 
provided.
2.  Pour lava rock onto plenum but not onto flat burner. It is not 
necessary to use all of the lava rock provided.
NOTICE:  Do  not  put  lava  rock  on  burner  or  under 
burner. Placing lava rock on burner will cause per-
formance problems.
3.  Close glass door, lock door latches, replace screen and close 
louvers (see Removing Glass Door, steps 5 through 7).
 WARNING: The glass door must be securely in 
place before running this fireplace. Do not run this 
fireplace if glass is missing or broken.
Figure 43 - Placing Ember Material on Burner
Embers
Plenum
Andiron