Hoshizaki 73180 用户手册

24

• This unit should be diagnosed and repaired only by qualified service personnel to 

reduce the risk of death, electric shock, serious injury, or fire.

• Risk of electric shock. Use extreme caution and exercise safe electrical practices. 
• Moving parts (e.g., fan blade) can crush and cut. Keep hands clear.
• 

CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are 

securely in place after the unit is serviced. Make sure that none have fallen into 
the storage bin.

• Make sure all food zones in the icemaker and storage bin are clean after the 

unit is serviced. For cleaning procedures, see "VI.B. Cleaning and Sanitizing 
Instructions."

To check production, prepare a bucket or pan to catch the ice and a set of scales 
to weigh the ice. After the icemaker has operated for 10 to 20 minutes, catch the ice 
production for 10 minutes. Weigh the ice to establish the batch weight. Multiply the 
batch weight by 144 for the total production in 24 hours. When confirming production 
or diagnosing low production, see "III.C. Performance Data" for typical production 
information. 

This diagnostic procedure is a sequence check that allows you to diagnose the electrical 
system and components. Before proceeding, check for correct installation, adequate 
water pressure (7 to 113 PSIG), and proper voltage per unit nameplate. When checking 
voltage (115VAC), always choose a neutral (W wire) to establish a good neutral 
connection.

1) Move the power switch to the "OFF" position, then unplug the unit from the electrical 

outlet.

2) Remove all ice from the storage bin.
3) Remove the rear panels.
4) Remove the front panel and louver. Remove the screws securing the control box, then 

gently pull out the control box. Remove the control box cover.

5) Plug the unit back in. Place the power switch in the "ON" position.