National Instruments USB-6525 data aquisition (DAQ) device 用户手册

© National Instruments Corporation

Refer to the 

 section of this document for important safety 

information.

Complete the following steps to set up the hardware:

1.

Install combicon screw terminal blocks by inserting them into the 
combicon jacks.

The USB-6525 kit ships with signal labels. You can apply the signal labels on the 

screw terminal blocks for easy signal identification. 

2.

Refer to Table 1 and Figure 4 for label orientation and affix provided 
signal labels to the screw terminal blocks. Insert the screw terminal 
blocks into their respective matching combicon jacks. Refer to 
Figure 4 for more information about signal label orientation.

Figure 4.  Signal Label Application Diagram

3.

Connect the wiring to the appropriate screw terminals.

1

Overlay Label with Pin Orientation Guides

2

Combicon Jack

3

Screw Terminal Blocks

4

Signal Labels

4

3

3

2

1

4