Lucent Technologies 6.1 用户手册

Issue 1

August 1998

Features 

Page 4-8

Telephone and Extension Features 

3.

If Remote Call Forwarding is enabled, do 

one of the following:

■

If you wish to disable the Forwarding Delay option, enter 

0

 in the 

Delay (0–9) column under the Remote Call Forwarding heading on 
Form 6b. This causes incoming calls to be forwarded immediately.

■

If wish to enable the Forwarding Delay option for an extension, enter 
the number of times an incoming call should ring at the called 
extension (1–9 rings) before the incoming call is forwarded.

1.

If Do Not Disturb (DND) and Forwarding Delay are both active, 
DND overrides the Forwarding Delay and the call is forwarded 
immediately.

2.

Due to the timing of when the ringing signal is applied to a 
single-line telephone, and the interval of that ringing signal, 
single-line telephones may appear to have their calls forwarded 
one ring sooner than the programmed number.

4

Use these instructions only when the system has fax machines connected directly 
to the control unit by way of an 008 OPT, 016 T/R, or 012 T/R module or 
connected to an MLX telephone using a Multi-Function Module (MFM). Otherwise, 
skip to the next section, “Operator Features.”

Fax machines cannot use General-Purpose Adapters (GPAs) because they 
cannot auto dial through the GPA.

This section contains instructions to designate from one to four telephones to 
receive message-waiting indications when a fax is received on a specific fax 
machine, and to specify the length of time before the system assumes a fax has 
arrived and sends the message-waiting indication.

4

Use Form 6d to identify up to 16 fax machine extension numbers and up to four 
receiver extension numbers for each fax number.

The System Notification Threshold setting can be left at the factory setting of 
10 seconds or changed and identified on the line at the top of the form for up to 
30 seconds.

You will fill in the rest of the optional telephone features later.