Amana T1WG2L 用户手册

NOTE: Not all bulbs will fit your refrigerator. Be sure to replace 
the bulb with one of the same size, shape and wattage. 
Replacement bulbs are available from your dealer.

■

The dispenser lights are LEDs that can not be changed.

■

All other lights require a 40-watt bulb.

1. Unplug refrigerator or disconnect power.

2. Remove light shield when applicable. 

NOTE: To clean the light shield, wash it with warm water and 
liquid detergent. Rinse and dry the shield well.

3. Remove light bulb and replace with one of the same size, 

shape and wattage.

4. Replace light shield when applicable.

5. Plug in refrigerator or reconnect power.

■

Power cord unplugged? Plug into a grounded 3 prong 
outlet.

■

Is outlet working? Plug in a lamp to see if the outlet is 
working.

■

Household fuse blown or circuit breaker tripped? Replace 
the fuse or reset the circuit breaker. If the problem continues, 
call an electrician.

■

Are controls on? Make sure the refrigerator controls are on. 
See “Using the Controls.”

■

New installation? Allow 24 hours following installation for 
the refrigerator to cool completely.   

NOTE: Adjusting the temperature controls to coldest setting 
will not cool either compartment more quickly.

Your new refrigerator may run longer than your old one due to its 
high-efficiency compressor and fans. The unit may run even 
longer if the room is warm, a large food load is added, doors are 
opened often, or if the doors have been left open.

Refrigerator noise has been reduced over the years. Due to this 
reduction, you may hear intermittent noises from your new 
refrigerator that you did not notice from your old model. Below 
are listed some normal sounds with an explanation.

■

Buzzing - heard when the water valve opens to fill the ice 
maker

■

Pulsating - fans/compressor adjusting to optimize 
performance

■

Rattling - flow of refrigerant, water line, or from items placed 
on top of the refrigerator

■

Sizzling/Gurgling - water dripping on the heater during 
defrost cycle

■

Popping - contraction/expansion of inside walls, especially 
during initial cool-down

■

Water running - may be heard when water melts during the 
defrost cycle and runs into the drain pan

■

Creaking/Cracking - occurs as ice is being ejected from the 
ice maker mold.

■

Door blocked open? Move food packages away from door. 

■

Bin or shelf in the way? Push bin or shelf back in the correct 
position.