Amana Bottom Mount Refrigerator 用户手册
November 1996
43
RS1200001
Ice Maker
Module Ohmmeter Checks
No Power to Ice Maker and
Ejector Blades in End of Cycle Position
Test Points
Component
Module Position
Ohms
L - H
Mold and heater
Attached to support
264
L - M
Motor
Separated from heater
16,100
Module Voltage Checks with Meter or Test Light
Power to Ice Maker
Test Points
Component
Line Voltage
0 Volts
L - N
Module
Power on
Power off
T - H
Bimetal
Open
Closed
L - H
Heater
On
Off
L - M
Motor
On
Off
N - V
Water valve
On
Off
Disassembly Procedures
Cover
1. Pull water adjustment knob forward.
2. Snap off cover.
1. Pull water adjustment knob forward.
2. Snap off cover.
Adjustment
screw
screw
Mold attachment
screw access ports
screw access ports
WARNING
To avoid electrical shock which can cause
severe personal injury or death, disconnect
power to refrigerator using power switch before
servicing. Wires removed during disassembly
must be replaced on proper terminals to insure
correct earthing and polarization. After
servicing, reconnect power using power switch.
severe personal injury or death, disconnect
power to refrigerator using power switch before
servicing. Wires removed during disassembly
must be replaced on proper terminals to insure
correct earthing and polarization. After
servicing, reconnect power using power switch.
Shut off arm
Module, Motor, and Support Assembly
1. Loosen both screws in module access ports.
2. Disconnect shut-off arm.
3. Pull mold from support assembly.
1. Loosen both screws in module access ports.
2. Disconnect shut-off arm.
3. Pull mold from support assembly.
Remove module only by removing 3 screws and
pulling module out of housing.
pulling module out of housing.
Shut-Off Arm
1. Pull shut-off arm out from white bushing.
2. Replace by pushing completely in.
3. Follow steps below.
1. Pull shut-off arm out from white bushing.
2. Replace by pushing completely in.
3. Follow steps below.
Module and Heater Assembly
1. Remove module and support assembly.
2. Install module and support assembly on
1. Remove module and support assembly.
2. Install module and support assembly on
replacement mold and heater assembly.
Fill Cup
1. Remove module and support assembly.
2. Remove ejector blades and shut-off arm.
3. Pull fill cup from mold.
1. Remove module and support assembly.
2. Remove ejector blades and shut-off arm.
3. Pull fill cup from mold.