GE 200D2600P010 用户手册
22
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Installing and removing previously installed decorator panels.
Removing the Handles
In order to remove the decorator panels and replace
with new panels you need to remove the handles.
A T-20 Torx driver is needed.
with new panels you need to remove the handles.
A T-20 Torx driver is needed.
Loosen and remove the 2 screws in the
Top Trim.
Loosen and remove the 2 screws in the
bracket that attaches the Handle to the
top of the Door.
Grip the Handle firmly and slide upwards.
The keyhole slots on the Handle slide off
the buttons on the door.
Open the door and slide out the decorator
panels.
Read these instructions completely and carefully.
Top Trim Screws
Bracket Screws
Slots
Slot
Button
Buttons
Bracket
Inserting the Door Panels
Before installing the decorator panels, make sure they have been routed out in the proper areas as shown in the
beginning of this section. Slide in the panels to perform a trial fit before fastening down the Handle and Top Trim.
beginning of this section. Slide in the panels to perform a trial fit before fastening down the Handle and Top Trim.
Slide the keyhole slots on the Handle down
onto the buttons mounted to the face of the
door. Slide the Handle downward until the
bracket at the top of the Handle fits flush on
the top of the door.
bracket at the top of the Handle fits flush on
the top of the door.
Replace the two screws in the bracket that
attach the Handle to the top of the Door and
tighten the screws to 45 in-lbs torque.
Replace the Top Trim making sure it fits over
the Side Trim and that the locating tabs fit the
inside of the Handle profile.
Replace the Top Trim screws and tighten to
30 in-lbs torque.
Installing the Handles
Once the panels are fitted properly, install the Handle and Top Trim.