GE 200D2600P010 用户手册

Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown. On the GE
SmartConnect™ Refrigerator Tubing kit, the nuts
are already assembled to the tubing.

•

Before making the connection to the refrigerator,
be sure the refrigerator power 
cord is not plugged into the wall outlet.

•

If your refrigerator does not have a water filter, 
we recommend installing one. If your water
supply has sand or particles that could clog the
screen of the refrigerator’s water valve. Install it in
the water line near the refrigerator. If using GE
SmartConnect Refrigerator Tubing kit, you will
need an additional tube (WX08X10002) to
connect the filter. Do not cut plastic tube to 
install filter.

Some models have the refrigerator connection at
the end of tubing located outside the compressor
compartment access cover. On other models the
compressor compartment access cover must be
removed in order to access the refrigerator
connection at the water valve.

On models using the refrigeration connection at
the water valve, remove the plastic flexible cap.

Insert the end of the tubing into the water valve
connection as far as possible. While holding the
tubing, tighten the fitting.

For plastic tubing from a GE SmartConnect™
Refrigerator Tubing kit, insert the molded end 
of the tubing into the refrigerator connection and
tighten the compression nut until it is hand tight,
then tighten one additional turn with a wrench.
Overtightening may cause leaks.

Fasten the tubing into the clamp provided to hold 
it in a vertical position. You may need to pry open
the clamp.

1/4

″

Compression 
Nut

Tubing
Clamp

1/4

″

Tubing

Ferrule 
(sleeve)

Refrigerator 
Connection

SmartConnect™
Tubing

1/4

″

Tubing

Tubing Clamp

1/4

″

Compression Nut

Ferrule 
(sleeve)

SmartConnect™ Tubing

Refrigerator Connection