GE 197D4613P004 使用和维护
8
C
o
n
su
m
e
r
S
u
p
p
o
rt
T
ro
u
b
le
sh
o
o
ti
n
g
T
ip
s
O
p
e
ra
ti
n
g
In
st
ru
c
ti
o
n
s
S
a
fe
ty
In
st
ru
c
ti
o
n
s
In
st
a
ll
a
ti
o
n
In
st
ru
c
ti
o
n
s
C
a
re
a
n
d
C
le
a
n
in
g
Care and cleaning.
If the power fails, open the door as
infrequently as possible to maintain
the temperature. A gradual rise in
temperature should not have any
adverse effect on the wine.
infrequently as possible to maintain
the temperature. A gradual rise in
temperature should not have any
adverse effect on the wine.
If it is extremely hot, you may want to
unload the wine from the beverage
center/wine chiller and move the wine
to a cooler location until power is restored.
unload the wine from the beverage
center/wine chiller and move the wine
to a cooler location until power is restored.
The controls may maintain your
temperature settings when the power
has been restored. If your settings are not
correct, reset according to the Control
Settings section.
temperature settings when the power
has been restored. If your settings are not
correct, reset according to the Control
Settings section.
In the Event of a Power Failure
Unload the wine, then secure the racks by
taping them in place to prevent damage.
taping them in place to prevent damage.
Be sure the beverage center/wine chiller
stays in an upright position during the move.
stays in an upright position during the move.
Preparing to Move
Replacing the light bulb.
Unplug the beverage center/wine chiller.
Remove any beverages and shelves as needed for access.
The light bulb is located behind a light shield in the ceiling of the
beverage center/wine chiller near the back. To remove the light
shield, remove the screw on the right side of the light shield.
beverage center/wine chiller near the back. To remove the light
shield, remove the screw on the right side of the light shield.
Pull down on the back of the light shield to release the two front tabs.
Unscrew the light bulb from the socket.
Replace with a 15 watt, 120 volt bulb. This type of bulb is available
at most hardware and automotive parts stores.
at most hardware and automotive parts stores.
WARNING:
Using a bulb rated higher than 15 watts may
damage the electronic controls on the beverage center/wine chiller.
Reinstall the light shield.
Replace the top shelf and beverages.
Plug in the beverage center/wine chiller.
Light Shield
Screw