GE ZIF36N RH 用户手册
33
Before you
begin:
begin:
Right hand door swing models are illustrated in these
instructions. Follow these instructions for left hand
models.
instructions. Follow these instructions for left hand
models.
This kit provides for the installation of a Tubular
Stainless Steel handle on a 3/4
Stainless Steel handle on a 3/4
″ thick decorator door
panel. The door extrusions allow the custom handle
to be secured to the door structure, rather than to
the custom panel.
• Select the extrusion for your model, discard other
to be secured to the door structure, rather than to
the custom panel.
• Select the extrusion for your model, discard other
extrusion.
Tools and materials required:
• #2 Phillips screwdriver
• Drill and 1/8
• #2 Phillips screwdriver
• Drill and 1/8
″, 9/32″ bits
• Custom door panel
• Safety glasses
• Center punch
• Masking tape
• Hammer
• Pencil
• Safety glasses
• Center punch
• Masking tape
• Hammer
• Pencil
Parts List:
A. Handle extrusion (for left hand models)
B. Handle extrusion (for right hand models)
C. Stainless tubular handle
D. 4 Handle standoffs
E. 6 Screws for handle standoffs
A. Handle extrusion (for left hand models)
B. Handle extrusion (for right hand models)
C. Stainless tubular handle
D. 4 Handle standoffs
E. 6 Screws for handle standoffs
(4 required, 2 extra)
F. 6 Set screws (4 required, 2 extra)
G. 3/32
G. 3/32
″ Allen wrench for set screws
This kit must be used in combination with ZKTR36RH
or ZKTR36LH trim kit.
or ZKTR36LH trim kit.
NOTE: It is best that 2 people install this kit.
• The 3/4
″ custom panel must be routed to
accommodate the handle extrusion. Rout the panel
as illustrated, 1/4
as illustrated, 1/4
″ deep, and 1-13/16″ wide, top to
bottom on the handle side.
• Follow the instructions in the ZKTR36RH
(or ZKTR36LH) to install trim onto the door.
Discard the handle supplied with that kit.
Discard the handle supplied with that kit.
• Continue the instructions in the ZKTR36RH
(or ZKTR36LH) trim kit to install support brackets
to the bottom of the panel.
to the bottom of the panel.
Kit
Contents
Contents
IMPORTANT: Optional final appearance depends on
careful routing depth. Do not exceed 1/4
careful routing depth. Do not exceed 1/4
″ routing
depth.
1-13/16"
Back Side
Handle Side
Custom Panel
1/4" Max.
A
B
D
E
G
F
C
ZKHTRSS1 (For 3/4
″ Panels)
Tubular Stainless Steel Handles