GE 21 用户手册

(on some models)

beneath the grille, should be wiped dry. Water

left in this area may leave deposits. Remove

the deposits by adding undiluted vinegar to

the well. Soak until the deposits disappear

or become loose enough to rinse away.

(on some models).

Before cleaning, lock the dispenser by

pressing and holding the LOCK CONTROL

pad for 3 seconds. Clean with warm 

water and baking soda solution—about 

a tablespoon (15 ml) of baking soda to 

a quart (1 liter) of water. Rinse thoroughly 

and wipe dry.

Clean with a 

cloth dampened with soapy water. Dry 

with a soft cloth. 

Wipe with a clean

cloth lightly dampened with kitchen

appliance wax or mild liquid dish detergent.

Dry and polish with a clean, soft cloth. 

Do not wipe the refrigerator with a soiled dish
cloth or wet towel. These may leave a residue
that can erode the paint. Do not use scouring
pads, powdered cleaners, bleach or cleaners
containing bleach because these products can
scratch and weaken the paint finish.

leave an open box of

baking soda in the fresh food and freezer

compartments.

If this

is not practical, wring excess moisture out 

of sponge or cloth when cleaning around

switches, lights or controls. 
Use warm water and baking soda solution—

about a tablespoon (15 ml) of baking soda

to a quart (1 liter) of water. This both cleans

and neutralizes odors. Rinse and wipe dry.

After cleaning the door gaskets, apply a thin

layer of petroleum jelly to the door gaskets

at the hinge side. This helps keep the

gaskets from sticking and bending out 

of shape. 

Avoid cleaning cold glass shelves with hot water
because the extreme temperature difference 
may cause them to break. Handle glass shelves
carefully. Bumping tempered glass can cause 
it to shatter.

Do not wash any plastic refrigerator parts in the
dishwasher.

To remove: 
Set the icemaker power switch to the OFF

position. Pull the drawer straight out and

then lift past the stop position.

To replace: 
When replacing the drawer, be sure to press

it firmly into place. If it does not go all the

way back, remove it and rotate the drive

mechanism 1/4 turn. Then push the

drawer back again.

Rotate

Drive
Mechanism

Dispenser drip area.

13