GE ZIR36N LH 用户手册
35
This kit provides for the installation of a 3/4
″ thick
custom grille panel to span the combined width of
a side by side installation. Use this kit in combination
with 3/4
a side by side installation. Use this kit in combination
with 3/4
″ custom panel kits, ZKTR36LH and
ZKTR36RH.
Tools and materials Required:
• #1 and #2 Phillips screwdrivers or sockets
• 1/4
• #1 and #2 Phillips screwdrivers or sockets
• 1/4
″ angled wrench and 1/2″ open-ended
wrench
• Drill and appropriate bits
• Custom grille panel
• Safety glasses
• Gloves to protect against
• Custom grille panel
• Safety glasses
• Gloves to protect against
sharp edges
Parts List:
A. Soffit Vent Top
B. Left Side Case Trim
C. Right Side Case Trim
D. Center U-Shape Trim
E. Grille Base Wrap
F. Custom Grille Panel Support
G. Foam Spacer Pads
A. Soffit Vent Top
B. Left Side Case Trim
C. Right Side Case Trim
D. Center U-Shape Trim
E. Grille Base Wrap
F. Custom Grille Panel Support
G. Foam Spacer Pads
Completion Time: Allow approximately 3 hours to
install this kit.
install this kit.
IMPORTANT:
2 People are required to install this kit.
CAUTION:
Disconnect power before you begin.
Step 1
Install Spacer Pads,
Replace Side Case Trims
Install Spacer Pads,
Replace Side Case Trims
CAUTION:
Handle parts with care to avoid scratching.
In a side by side installation, the inside case trim of
both products will be removed and replaced with a
shorter trim.
• Lift up to remove the supplied grille panel assembly
both products will be removed and replaced with a
shorter trim.
• Lift up to remove the supplied grille panel assembly
on both products. Discard both assemblies.
• Apply the supplied foam spacer pads to the mating
side of one product as shown.
• Remove the Phillips head screws from the inside
case trim of each product as shown. Remove and
discard side trim. Retain screws.
discard side trim. Retain screws.
• Install new side case trim with notches towards the
bottom. Install with original screws.
Foam
Spacer
Pads
Spacer
Pads
A
B
C
D
E
F
G
ZUG75 Trim Kit
Unified 3/4
″ Custom Grille Panel Kit