Dacor DYF48BIWS 用户手册

Complete Installation

1.  Turn the water supply line valve to the “Open” position.

2.  Turn the refrigerator switch to the ON position. See Power On/

Off Switch in the use and care manual for instructions. Wait a 
few minutes. Check the water line connections for leaks.

3.  Remove all boxes, parts packages and packing materials from 

the interior of the refrigerator. See the Care and Cleaning 
section in the use and care manual for instructions. Remove 
the film and cardboard from the grille and doors or door frame, 
depending on your model.

4.  Install the shelves and bins in the refrigerator and freezer 

compartments.

5.  The controls are preset at the factory to the midpoint setting. 

Check that the compressor is operating properly and that all 
the lights are working.

6.  Flush the water system before use. See below.

Water System Preparation

Please read before using the water system.

IMPORTANT: After connecting the refrigerator to a water source 
or replacing the water filter, follow the steps below to make sure 
that the water system is properly cleaned. This will flush air from 
the filter and water dispensing system, and prepare the water filter 
for use.

1.  Open the freezer door and turn off the ice maker. Move the 

switch to the OFF (right) setting as shown. The On/Off switch 
is located on the top right side of the freezer compartment.

NOTE: If your model has a base grille filter system, make sure 
the base grille filter is properly installed and the cap is in the 
horizontal position.

2.  Use a sturdy container to depress and hold the water 

dispenser lever for 5 seconds, then release it for 5 seconds. 
Repeat until water begins to flow. Once water begins to flow, 
continue depressing and releasing the dispenser lever (5 
seconds on, 5 seconds off) until a total of 3 gal. (12L) has 
been dispensed. Additional flushing may be required in some 
households.

NOTE: As air is cleared from the system, water may spurt out of 
the dispenser.

Installation Instructions

3.  Open the freezer door and turn on the ice maker by moving 

the switch to the ON (left) position.

 

ƒ Allow 24 hours to produce the first batch of ice.

 

ƒ Discard the first three batches of ice produced.

 

ƒ Depending on your model, you may want to select the 

maximum ice feature to increase the production of ice.

To get the most efficient use from your new built-in refrigerator, 
read your use and care manual. Keep Installation Instructions and 
the use and care manual near the refrigerator for easy reference.

Any questions or problems with this installation should be directed 
to your Dacor dealer or the Dacor Customer Service Team at 
(800) 793-0093 or visit our web site at www.dacor.com.

If you need service, be sure to have the model and serial 
numbers when you call. You’ll find these numbers on the serial 
number plate, located on the right hand side of the fresh food 
compartment.

Ice Maker