Smeg SCV36X 用户手册

Whenever the cellar is receiving power, even if it is not in operation, the LED 

 indicating that it is

powered up will illuminate. Once the LED is on, press the button 

 to put the cellar into operation. The

display will show the actual temperature inside the cellar when it is switched on. You can now move on to
set the temperature you require.

The default temperature at which the thermostat is set is 15°C. If you wish to change this, simply
proceed as follows:
-  Press button 

 for a few seconds until the figure shown on the display starts to flash;

-  use buttons 

 and 

 to set the temperature value you require;

-  about 5 seconds after the last key is pressed, the display stops flashing and the chosen temperature

remains set.

Depending on whether the temperature set is higher or lower than the current temperature inside the
cellar, the appliance will start to heat up or cool down and the LEDs 

 or 

. will illuminate accordingly.

To switch on the line inside the cellar, simply press key 

.