Invacare 9871 用户手册

SPECIFIC WARNINGS (CONTINUED)

Most tub floors are higher than the bathroom floor. Before using, ensure that

the two (2) legs of the transfer bench inside the tub are adjusted to the same

height and the two (2) legs outside the tub are adjusted to the same height,

so as to achieve an even height adjustment. DO NOT use if wobbly or

unstable.

After ANY adjustments, repair or service and BEFORE use, make sure

all attaching

hardware is securely tightened - otherwise injury or damage may result.

INSTALLING THE SEAT ARM

NOTE: Before performing this procedure, carefully read and understand the Safety
Summary of this instruction sheet.

NOTE: The end rail is already installed on the transfer bench and must be removed when
installing the seat arm.

1. Remove the two (2) LONGER mounting screws and locknuts that secure the leg

frame to the end rail.

NOTE: The LONGER mounting screws are the ones that have more exposed threads
beyond the lock nut.

2. Position the seat arm on the side of the transfer bench where backrest is

attached.

3. Install one (1) LONGER mounting screw through seat arm and leg frame.

4. Secure seat arm to the leg frame

with the locknut.

NOTE: Locknut located on inside or end
rail side of product.

5. Repeat STEPS 3 AND 4 for opposite

side.

6. Securely tighten all hardware until

a resistance is felt and all slack is
removed.

Leg Frame

End Rail

Seat Arm

LONGER

Mounting

Screw

Locknut