Jenn-Air W10201609B 用户手册

4. Attach 1 undercounter bracket on front upper right corner of

downdraft vent with slot over vent mounting hole and flange
against countertop. Attach other bracket to left side of the
downdraft vent. Drill starter holes through undercounter
mounting brackets into the underside of the countertop.
Insert appropriate length screws into holes and tighten
brackets to countertop.

Make Electrical Connections

1. Disconnect power.
2. Feed the power supply cable through the conduit connector

and into the terminal box.

3. Attach the green (or green and yellow) ground wire to the

green ground screw. Tighten the conduit connector clamp
screws.

4. Connect the 2 white wires together using UL listed wire

connectors.

5. Connect the 2 black wires together using UL listed wire

connectors.

6. Replace the terminal box cover and secure with screw.

7. Reconnect power.

Check Operation

1. Push and hold the button on the top of the downdraft vent for

a few seconds. The retractable section of the downdraft vent
will rise, and the blower will start. Position the top trim over
the retractable section and snap trim into place.

Trim kits for matching your cooktop color are available from
your dealer.

For information on ordering, see the “Assistance or Service”
section.

2. Slide the control slider on the side of vent to check the

operation and speed of the blower.

3. If the blower does not operate:

■

Check that filter or filters are pressed in as far as they will
go.

■

Check that the circuit breaker has not tripped or a
household fuse blown.

■

Check downdraft fuse located under power board.

4. Connect vent system to blower. Vent system must end with a

wall or roof cap. Use clamps to seal all joints.

A. When attaching undercounter bracket to underside

of countertop, make sure that the screw length will
not go through countertop when tightened.

B. Backsplash

C. Countertop

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

WARNING

Fire Hazard

Electrically ground the blower.

Use copper wire.

Connect ground wire to green ground screw in
terminal box.

Failure to do so can result in death, fire, or
electrical shock.

A. Green or green and yellow ground wire
B. Green ground screw

C. White wires
D. UL listed wire connectors

E. Black wires
F. UL listed or CSA approved conduit connector

G. Downdraft vent wiring

A. Top trim
B. ON/OFF button

C. Blower control slider
D. End cap

E. Filters