Manitowoc Ice K00117 产品宣传页

1.  Use the K00117 to install a 22" B, J, Q, S, and Flaker/Chip ice machines on a Manitowoc C-730 bin. 
2.  Installation (bin to be level before starting): 

A.  Remove the hinge on the right and left side of the bin. 
B.  Remove the foam tape on the right and left rail.  Trim back the foam tape on the front and rear bin rails, as 

shown. 

C.  Position the adapter panels and hinges on bin and fasten with the four existing hinge screws. 
D.  Using the adapters as templates, drill four 5/32” (4 mm.) holes, .500” (12.7 mm.) deep maximum, in the rear of 

the bin (adapters must be level with bin).  Warning:  Do not drill through interior liner.  Attach with the 
screws provided. 

E.  Apply foam tape to the edge of the adapters, as shown.  Note: We recommend using RTV at intersections and 

along front inside edge of foam tape to prevent water tracking.  Use double thickness with S-series ice 
machines. 

3.  Refer to ice machine installation manual for ice machine installation procedures. 
 

 

Manitowoc Ice, Inc. 

2110 South 26

th

 Street, P.O. Box 1720, Manitowoc, WI  54221-1720 USA                                                                                                

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879                                              8009133    
Web Site - www.manitowocice.com                                                                                                                                                    Rev. 05/06/04 

 

 

Ice 
Machine
Back 

Existing two screws 
 
Hinge 

Foam tape from kit - (trim to 
fit) two places - double tape 
thickness, when used with 
S-series ice machines 

Screws from kit 

Existing two 
screws 
 
 
Hinge 
 
 

Trim back existing 
foam tape 11 3/16” 
from outer edge of bin 
(four places) 

Drill two 5/32” dia. 
holes each side (use 
adapter as a template to 
locate holes on bin) 

Important 
Do not drill through 
the inside of the bin 
liner - only through 
outer metal. 

Bin 

22.00"