Manitowoc Ice K00180 产品宣传页

 

1. 

Set adapter on top of the dispenser.  Be sure to position the adapter with the backside flange tight to the dispenser. 

2. 

Install bracket under adapter and align front edge. 

3. 

Using the slotted holes in the adapter as a template, drill four (4) 9/64” diameter holes at the bottom of the slots.  
NOTE:  Do not drill deeper than 1/4” past the sheet metal.  Use a drill stop! 

4. 

Fasten adapter to dispenser using the four (4) #8 screws supplied with the adapter kit. 

5. 

Set the ice machine on top of the adapter.  Align holes in ice machine front angle with the rivnuts on the adapter. 

6. 

Secure the ice machine to the adapter with two (2) #8-32 thumbscrews supplied with the ice machine. 

7. 

Set the front bin covers onto the dispenser.  Set the left side cover down first and then the right side cover.  The 
covers will latch together at the center seam and also to the adapter along the back flange of the covers. 

8. 

Rotate retaining arms into position, as shown for normal ice machine operation. 

 
 

Manitowoc Ice, Inc.                                                                                                                            
2110 South 26 Street, P.O. Box 1720, Manitowoc, WI  54221-1720 USA                                                                                                   
Telephone 920-682-0161, Fax - Sales:  920-683-7589, Service/Parts: 920-683-7585,  Other:  920-683-7879                                                  8005913                   
Web Site - www.manitowocice.com                                                                                                                                                            Rev. 04/12/02 

#8-32 Thumbscrew 
Two (2) Places 

Left Bin 
Cover 

Adapter 

LH Retaining Arm 

#8 Screw  
4 Places 

Right Bin 
Cover

RH Retaining 
Arm

Bracket