Hoshizaki SRH/3 KM-1400SWH-M 用户手册

35

To check thermistor resistance, follow the steps below.

1) Turn off the power supply. 
2) Remove the front panel. Move the control switch to the "OFF" position.
3) Remove the control box cover.
4) Remove the thermistor from the refrigerant tubing. 
5) Immerse the thermistor sensor portion in a glass containing ice and water for 2 or 3 min.
6) Disconnect the thermistor connector from CB K3 connector and check the resistance 

between thermistor leads. Normal range is 4.7 to 6.2 kΩ. If outside the normal range, 
replace the thermistor. See "IV.B. Component Service Information." If within the normal 
range, continue to the next step.

7) Replace the thermistor in its correct position. See "IV.B. Component Service 

Information."

8) Reconnect the thermistor connector to CB K3 connector.
9) Replace the control box cover in its correct position.

10) Move the control switch to the "ICE" position. 
11) Replace the front panel in its correct position.
12) Turn on the power supply.
13) Once the harvest cycle starts (Comp energizes), begin timing the harvest cycle.
14) The harvest timer and harvest cycle should terminate within 2 to 5 min. If the harvest 

cycle does not terminate within 2 to 5 min., replace CB.

Legend: 

CB–control board; Comp–compressor

Foam Insulation   

Thermistor Holder

Thermistor Lead   

Cable Tie