GE 164 D2092P127 用户手册

I

 light, first

Remove screw on right side of light
compartment cover and lower cover
until it stops.

 sure bulbs to be replaced are

cool before removing. Break the
adhesive seal by gently unscrewing
the bulbs. Replace with 40-watt

incandescent bulbs 

available from your GE supplier.

High intensity 40-watt bulbs

 which are available in

supermarkets and hardware stores,
may also be used 

 replacements.

Raise light compartment cover and
replace screw. Connect electrical
power to microwave oven.

To replace your oven light, first
disconnect power at main fuse
or circuit breaker panel or pull
plug. Remove the top grill by
taking out the 2 screws that hold

it in 

Next, remove the single screw
located above door near center of

oven that secures light housing.
Replace burned-out bulb with 
30-watt incandescent bulb

 available from

your GE supplier.

Clean off the grease and dust on
hood surfaces often. Use a solution

 warm water and detergent. About

1 tablespoon of ammonia may be

added to the water. Take care not
to touch the filters and enamel
surfaces with this solution;
ammonia will darken 

This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an 
that is properly installed and
grounded. (Fig. 1)

WARNING-Improper

use of the grounding 

plug can 

in a risk 

 

Consult a qualified electrician or
service technician if the grounding
instructions 

 not completely

understood, or if doubt exists as to
whether the appliance is properly
grounded.

Where a standard two-prong wall

receptacle is encountered, it is

your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.