GE ZSA2201 用户手册

下载
页码 80
35
Care and Cleaning
Advantium Oven
Replacing the 
surface light
1.  To replace the surface light, first 
disconnect the power at the main fuse 
or circuit breaker panel.
2.  Remove the screw from the side of 
the light compartment cover and lower  
the cover until it stops.
3.  Be sure the bulb to be replaced is 
cool before removing.  Gently pull the 
bulb from the receptacle.
Replace with a 130 volt, 50-watt 
halogen bulb.  Order WB08X10051 
from your GE supplier.
4.  Raise the light cover and replace 
the screw.  Connect electrical power to 
the oven.
1.  The metal filters trap grease 
released by foods on the cooktop.  
They also prevent flames from 
foods on the cooktop from 
damaging the inside of the oven.
2.  For this reason, the filters must 
always be in place when the hood 
is used.  The vent filters should 
be cleaned once a month, or as 
needed.
3.  To remove, slide them to the rear 
using the tabs.  Pull down and out.
4.  To clean the vent filters, soak them 
and then swish around in hot water 
and detergent.  Don’t use ammonia 
or ammonia products because 
they will darken the metal.  Light 
brushing can be used to remove 
embedded dirt.
5.  Rinse, shake and let dry before 
replacing.
6.  To replace, slide the filters into the 
frame slots on the back of each 
opening.  Press up and to the front 
to lock into place.
Removing 
and cleaning 
the filters
Replacing the 
oven cavity 
lamp
1.  Disconnect power at the main fuse 
or circuit breaker panel.
2.  Remove the top grill by removing 
the two screws that hold it in place.
3.  Remove charcoal filter if present.  
Slide the filter toward the left and 
pull toward the front to remove.  
NOTE: 
 Charcoal filter is an optional 
kit, you may not have one.  
4.  Remove the screw holding the lamp 
shield in place.
5.  Pull the lamp shield out. Pull the 
light bulb out and replace with a 
120V-130V, 20 watt halogen bulb.  
Order WB25X10019 from your GE 
supplier.
6.  Return the lamp and lamp shield to 
original position and replace screw 
and charcoal filter.
7.  Replace the grill and 2 screws.  
Reconnect power to the oven  
Remove screw