GE 164 D2092P167 用户手册

DOES 

Difficulty may be in the main distribution panel of your 

 

 by a blown oven

circuit fuse, a tripped oven circuit breaker, the main fuse or the main circuit breaker,

depending on nature of 

 power supply. If a circuit breaker is involved, reset it.   the

control box uses fuses, 

 oven fuse (a cartridge-type) should be changed BUT ONLY

 SOMEONE FAMILIAR WITH 

 CIRCUITS. If, after performing

 of these procedures, the fuse blows or circuit breaker trips 

 call for service.

NOTE: Apartment tenants or condominium 

 

 request their building

management to perform this check before calling for service.

Oven controls are not properly set.

On self-cleaning oven, door left in locked position after cleaning.

 OVEN

Check to be certain step-by-step directions were followed correctly. Review pages on

TIMER DOES 

use of timer.

WORK PROPERLY

FOOD DOES NOT

OVEN SET knob not set at 

BROIL PROPERLY

OVEN TEMP knob not set at BROIL.

Door 

 left ajar as recommended.

Improper shelf position is being used. Check Broiling Guide.

When using special meat thermometer (on models so equipped), end not inserted fully
into oven receptacle or probe not placed in food properly.

Necessary preheating was not done.

Food is being cooked on hot pan.

Cookware is not suited for broiling.

Aluminum foil used on the broil pan rack has not been fitted properly and slit as
recommended.

FOOD DOES NOT

OVEN SET knob not set on BAKE.

ROAST OR BAKE
PROPERLY

OVEN TEMP knob not set correctly.

Shelf position is incorrect. Check Roasting or Baking Guide.

Oven shelf is not level.

When using meat thermometer (on models so equipped), end not fully seated in oven
receptacle or probe end not in meat correctly.

Wrong cookware is being used. When roasting, pan is too small.

A foil tent was not used when needed to slow down browning during roasting.

OVEN WILL 

Automatic timer 

 not set or not set properly. The 

 dial must be set and

SELF-CLEAN

advanced beyond the time noted on oven clock.

The STOP dial was not advanced for long enough.

Both OVEN SET and OVEN TEMP knobs must be at CLEAN setting.

A thick pile of spillover when cleaned 

 a heavy layer of ash in spots which could

have insulated the area from further heat.

Latch not moved to the right.