Whirlpool Series 945 用户手册

下载
页码 44
11
Fold-down tines (on some models)
You can fold down one row of tines at the back of the bottom 
rack.
1.
Grasp the tip of the tine that is in the tine holder.
2.
Gently pull the tine out of the tine holder.
3.
Lay the row of tines down in the rack to make room for larger 
dishes, bowls, pots, pans or roasters.
Loading the Silverware Basket
Load the silverware basket while it is in the dishwasher or take 
the basket out for loading on a counter or table. 
NOTE:
 Unload or remove the basket before unloading the racks 
to avoid spilling water droplets on the silverware.
To open the silverware basket
Unlock the latch.
NOTE:
 Be sure the cover is completely latched before pulling out 
the bottom rack and before closing the dishwasher door.
Place small items like baby bottle caps, jar lids, corncob 
holders, etc., in the section(s) with hinged cover(s). Close the 
cover to hold small items in place.
Mix items in each section of the basket with some pointing up 
and some down to avoid nesting. Spray cannot reach nested 
items.
IMPORTANT:
 Always load sharp items (knives, skewers, etc.) 
pointing down.
The silverware basket can be hung on the door or on the 
bottom rack (see illustration).
The silverware basket can also be placed inside the bottom 
rack.
To remove the basket from the door
1.
Grasp the silverware basket by the handle. Slide it toward the 
top of the door.
2.
Lift the basket off the holding buttons.
To replace the basket in the door
1.
Set the silverware basket on the holding buttons.
2.
Slide the basket toward the bottom of the door until it locks 
into place.
NOTES:
Do not load silver or silver-plated silverware with stainless 
steel. These metals can be damaged by contact with each 
other during washing.
Some foods (such as salt, vinegar, milk products, fruit juices, 
etc.) can pit or corrode silverware. Run a rinse cycle if you do 
not have a full load to wash immediately.
Cutlery Basket (on some models)
Use the cutlery basket to hold long items. Always unload or 
remove the cutlery basket before unloading the racks to avoid 
spilling water onto the cutlery.
NOTE:
 Remove the basket and tip the contents onto a cutting 
board to unload. This helps avoid accidents with sharp points 
and edges.
To remove the cutlery basket
1.
Grasp the basket on both sides and slide it toward the top of 
the door.
2.
Lift the basket off the holding buttons.
To replace the cutlery basket
1.
Set the basket on the holding buttons.
2.
Slide the basket toward the bottom of the door until it locks 
into place.