Whirlpool W10167841A 用户手册

1. Drill a 

¹⁄₂" (1.3 cm) hole in the left-hand cabinet side, the rear or 

floor of opening.

2. Measure the overall length of the copper tubing required.

3. Attach the copper tubing to the water supply line with a 

manual shutoff valve.

4. Slowly feed the copper tubing through the hole in the cabinet. 

NOTE: The copper tubing will bend and kink easily. 

The copper tubing should be far enough into the cabinet 
opening to connect it to the dishwasher inlet on the front left-
hand side of the dishwasher.

5. Turn on the water shutoff valve. Run water into a shallow pan 

to flush the copper tubing of particles that may clog the inlet 
valve.

6. Turn off the shutoff valve.

IMPORTANT: Always use a new drain hose even when installing 
a new replacement dishwasher.
1. Drill a 1

¹⁄₂" (3.8 cm) diameter hole in the cabinet wall or floor on 

the side of the opening closest to the sink.

2. Remove the waste disposal knockout plug. Cut the end of the 

drain hose, if needed.
NOTE: Do not cut the ribbed section.

3. Attach the drain hose to the air gap with the large spring-type 

clamp.
NOTE: If the drain hose was cut, use 1

¹⁄₂" to 2" (3.8 to 5 cm) 

screw-type clamp (not provided).

4. Use a rubber hose connector (not provided) with spring- or 

screw-type clamps (not provided) to connect the air gap to the 
waste disposal inlet above the drain trap and at least 20" 
(50.8 cm) above the floor.

5. Insert the drain hose through the hole cut in the cabinet and to 

the center front of the opening where the drain connection will 
be made.

IMPORTANT: Always use a new drain hose even when installing 
a new replacement dishwasher.
1. Drill a 1

¹⁄₂" (3.8 cm) diameter hole in the cabinet wall or floor on 

the side of the opening closest to the sink.

2. Cut the end of the drain hose, if needed.

NOTE: Do not cut the ribbed section.

-

-