GE 165D4700P126 用户手册
Safety Information
Operating Instructions
Troubleshooting T
ips
Customer Service
Before you call for service…
20
Troubleshooting Tips
Problem
Possible Causes
What To Do
Water standing in
This is normal
•
A small amount of clean
the bottom of the tub
water around the outlet on
the tub bottom at the back
of the tub keeps the water
seal lubricated.
the tub bottom at the back
of the tub keeps the water
seal lubricated.
Water won’t pump
Drain is clogged
•
If you have an air gap,
out of the tub
clean it.
•
Check to see if your kitchen
sink is draining well. If not,
you may need a plumber.
sink is draining well. If not,
you may need a plumber.
•
If the dishwasher drains
into a disposer, run
disposer clear.
into a disposer, run
disposer clear.
Suds in the tub
Correct detergent
•
Use only automatic
wasn’t used
dishwasher detergents to
avoid sudsing.
avoid sudsing.
•
To remove suds from the
tub, open the dishwasher
and let suds evaporate.
Add 1 gallon of cold water
to the tub. Close and latch
the dishwasher. Pump out
water by slowly turning the
Dial until a drain period
is reached. Repeat if
necessary.
tub, open the dishwasher
and let suds evaporate.
Add 1 gallon of cold water
to the tub. Close and latch
the dishwasher. Pump out
water by slowly turning the
Dial until a drain period
is reached. Repeat if
necessary.
Rinse agent
•
Always wipe up rinse agent
was spilled
spills immediately.
Steam
This is normal
•
Steam comes through the
vent by the door latch
during drying and when
water is being pumped out.
vent by the door latch
during drying and when
water is being pumped out.