Husqvarna FS 6500 用户手册
14
• Mandatory
• Obligatorio
• Obligatorio
• Prohibition
• Prohibición
• Prohibición
• Indication
• Indicación
• Indicación
• Warning Triangle
• Triángwulo De
Advertencia
• Triángwulo De
Advertencia
These signs will give advice for your safety
Before leaving our factory every machine is
thoroughly tested.
thoroughly tested.
Follow our instructions strictly and your
machine will give you long service in normal
operating conditions.
machine will give you long service in normal
operating conditions.
1. Features
Use: Wet sawing of old and new concrete
and asphalt.
and asphalt.
Tools: Diamond blades — water cooled, Ø:
12",14", 18", 20", 24", 26", 30", 36" with
Arbor Ø - 1".
(For information contact your Dealer)
12",14", 18", 20", 24", 26", 30", 36" with
Arbor Ø - 1".
(For information contact your Dealer)
Depth of Cut (Maximum):
Maximum Cutting Depth
Blade
Diameter
12” 14” 18” 20” 24”
Maximum
Cutting
Depth
3.5” 4.5”
6.5” 7.5” 9.5”
Maximum Cutting Depth
Blade
Diameter
26” 30” 36” -- --
Maximum
Cutting
Depth
10.5” 12” 15” --
--
Maximum material Size: N/A
Nominal & Operating Weight: See
“Specifications”.
“Specifications”.
Dimensions & Shaft RPM: See “Saw
Dimensions”.
Dimensions”.
Before starting up machine make sure
you read these instructions and are
familiar with the operation of this
machine
you read these instructions and are
familiar with the operation of this
machine
.
The working area must be completely clear,
well lit and all safety hazards removed (no
water or dangerous objects in the vicinity)
well lit and all safety hazards removed (no
water or dangerous objects in the vicinity)
The operator must wear
protective clothing
appropriate to the work he
is doing.
protective clothing
appropriate to the work he
is doing.
We recommend hearing,
respiratory and eye
protection.
respiratory and eye
protection.
Any persons not involved in the work,
should leave the area.
should leave the area.
Only work of flat horizontal areas.
Working on steep slopes or hills could
cause the operator to lose control of the
machine. This could result in injury or
death to the operator or other persons in
or near the work area!
Working on steep slopes or hills could
cause the operator to lose control of the
machine. This could result in injury or
death to the operator or other persons in
or near the work area!
Use only blades marked with a
maximum operating speed greater
than the blade shaft speed.
maximum operating speed greater
than the blade shaft speed.
2. Assembly
When unpacked, this unit is fully
assembled, except for installation of the
Muffler. For tool installation see Section 4
of this document.
assembled, except for installation of the
Muffler. For tool installation see Section 4
of this document.
3. Check Before Operating
All Models:
Take into account the working conditions from
a health and safety point of view.
a health and safety point of view.
For start up refer to the engine, or motor
manual.
manual.
Engine Fuel: Check the engine operation
manual. Unleaded gasoline is recommended.
manual. Unleaded gasoline is recommended.
Engine Oil: When the engine is in a horizontal
position, check that the engine oil level is
position, check that the engine oil level is