Husqvarna 326R 用户手册

14 – 

English

•

To fit the trimmer head, first separate the two halves (see 
diagram). Proceed as follows:

Insert a finger into the centre hole of the cover (I) while 
grasping the cover with your other fingers. Using the index 
finger and thumb of your other hand, release the two 
catches (J) that engage in the cut-outs in the bottom half 
(K). Pull apart the trimmer head, grasping the cover firmly.

•

Place the cover (I) and the support flange (F) on the 
output shaft.

•

Fit the nut (G). Tighten the nut to a torque of 35-50 Nm 
(3.5-5 kpm). Use the socket spanner in the tool kit. Grasp 
the handle of the spanner as close to the trimmer guard 
as possible.

•

To tighten the nut, turn the spanner in the opposite 
direction to the direction of rotation (Caution! left-hand 
thread).

•

Fit the bottom half of the trimmer head (K) to the cover (I) 
by pressing them together, with the cut-outs on the bottom 
half aligned with the catches on the cover.

•

To dismantle, follow the instructions in the reverse order.

•

Fit the trimmer guard/combination guard (A) intended for 
use with the trimmer head/plastic blades. Hook the guard 
onto the fitting on the shaft and secure it with the bolt (L).

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Screw on the trimmer head/plastic blades (H) in the 
opposite direction to the direction of rotation.

•

To dismantle, follow the instructions in the reverse order.