Grizzly G0495X 用户手册
g0495X 8" Jointer w/digital readout
-21-
7)8
-2
figure 22. set value entered.
3. hold the tol button down and move the
cursor right three digits until the digit flashes,
then press tol once to increase the value to
00.100".
then press tol once to increase the value to
00.100".
4. hold tol down to move the cursor right one
digit until it flashes, then press tol twice
to change that digit to 2 so the value reads
+00.120".
to change that digit to 2 so the value reads
+00.120".
5. repeat Step 4 in a similar manner to change
the next digit to 5 so the display value is now
+00.125".
+00.125".
figure 23. setting upper limit.
7)8
-2
7)8
-2
figure 24. setting lower limit.
TOL: use to set the tolerance limits.
in ABs mode, first set the reference dimension,
then set the upper and lower tolerance values.
While setting the tolerance limits, you will not be
able to use the sensor to measure depth of cut.
then set the upper and lower tolerance values.
While setting the tolerance limits, you will not be
able to use the sensor to measure depth of cut.
the upper tolerance limit value must be greater
than the lower limit value, otherwise an error code
(e-01) will appear. if this happens, press zero to
return to ABs mode.
than the lower limit value, otherwise an error code
(e-01) will appear. if this happens, press zero to
return to ABs mode.
for example, to set the reference dimension at
00.063", upper tolerance at 00.125", and lower
tolerance at 00.000":
1. Follow the instructions for setting the refer-
ence dimension to 00.063" on
page 20, then
enter ABs mode.
2. press the tol button. set flashes and
is displayed, indicating the upper limit mode
setting, as shown in
setting, as shown in
figure 23.
7. to select a lower limit value of +00.000", hold
the tol button down and move the cursor to
set, then press tol again. the tolerances
are set.
set, then press tol again. the tolerances
are set.
8. raise and lower the infeed table to verify the
tolerance settings.
—if the infeed table is raised or lowered
between 00.125" and 00.000", oK displays
on the screen.
on the screen.
—if the infeed table is lowered below 00.125"
the appears.
—if the infeed table is raised above 00.000"
the appears with a "–".
9. to change the tolerance limits, repeat Steps
2-7.
10. to exit tol mode, briefly press the tol but-
ton until all tol mode icons disappear and
only the preset value 00.063" appears.
only the preset value 00.063" appears.
5. hold set down until "set" blinks on the dis-
play, then press set again to set the value.
the preset value can be set positive (+) or nega-
tive (–). When the "+" flashes, press set to toggle
between "–" and "+".
tive (–). When the "+" flashes, press set to toggle
between "–" and "+".
6. hold the tol button down and move the cur-
sor until set flashes, then press tol again.
set flashes and is displayed, indicating the
lower limit mode, as shown in
set flashes and is displayed, indicating the
lower limit mode, as shown in
figure 24.