Grizzly G0495X 用户手册
-38-
g0495X 8" Jointer w/digital readout
the infeed table on the model g0495X has
positive stop bolts that, when properly set up,
allow the operator to quickly adjust the infeed
table between finish/final cuts and shaping/heavy
cuts.
positive stop bolts that, when properly set up,
allow the operator to quickly adjust the infeed
table between finish/final cuts and shaping/heavy
cuts.
We recommend setting the minimum depth of cut
to
to
1
⁄
32
" and the maximum depth of cut to
1
⁄
8
" for
most operations.
DO NOT exceed
1
⁄
8
" cut per
pass on this machine or the risk of kickback
and serious injury will be greatly increased!
each positive stop bolt (
figure 56) controls the
top or bottom range of the table movement. the
jam nuts lock the positive stop bolts in position so
they won't move during operation.
jam nuts lock the positive stop bolts in position so
they won't move during operation.
Setting Infeed Table
figure 56. infeed table positive stop bolts.
top height
Jam nut
Jam nut
figure 57. infeed table adjusted even with
outfeed table.
HigV^\]iZY\Z
>c[ZZY
Dji[ZZY
calibrating Infeed
Table
the depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
brated or "zeroed" if it is not correct.
Tools Needed
Qty
straightedge ...................................................... 1
Wrench 12mm ................................................... 1
Wrench 12mm ................................................... 1
To calibrate the depth scale:
1. set the outfeed table height as described in
Setting Outfeed Table height on page 15.
2. move the cutterhead guard out of the way.
3. place a straightedge across the infeed and
outfeed tables.
4. Adjust the infeed table until it is level with the
outfeed table, as illustrated in
figure 57.
5. Follow instructions on page 39 to calibrate
the digital sensor and readout so both dis-
play 0.000.
play 0.000.
Bottom
height