Grizzly G0495X 用户手册
g0495X 8" Jointer w/digital readout
-43-
— if the pulleys are aligned, go to
Step 8.
— if the pulleys are not aligned, perform
Steps 4–8.
4. loosen the motor mount fasteners shown in
figure 72.
figure 71. pulleys aligned.
Cutterhead
Pulley
Motor
Pulley
!LIGNMENT
figure 72. motor mount fasteners.
5. shift the motor horizontally as needed to align
the motor pulley with the cutterhead pulley.
6. tighten the motor mount fasteners. the
V-belt should be parallel and aligned as
shown in
shown in
figure 71.
7. reinstall the fence assembly, rear access
panel, and V-belt guard.
pulley Alignment
pulley alignment is another important factor in
power transmission and belt life. the pulleys
should be parallel to each other and in the same
plane (coplaner) for optimum performance.
power transmission and belt life. the pulleys
should be parallel to each other and in the same
plane (coplaner) for optimum performance.
each pulley can be adjusted by loosening the
motor mount fasteners, sliding the motor in or out,
and retightening the fasteners to lock the motor
pulley in place.
motor mount fasteners, sliding the motor in or out,
and retightening the fasteners to lock the motor
pulley in place.
Tools Needed:
Qty
Wrench or socket 17mm ................................... 1
To align the pulleys:
1. disConneCt Jointer From poWer!
2. remove the rear access cover, V-belt guard
and the fence assembly.
3. place a straightedge against both pulleys
(
figure 70) and check to make sure that they
are aligned and that the V-belt is straight up
and down (see
and down (see
figure 71).
figure 70. Checking belt alignment.
Fasteners
straightedge