Husqvarna PA 1100 用户手册
English
– 13
ASSEMBLY
Fitting the cutting head
(Saw attachment with shaft PA 1100)
•
Fit the cutting head on the shaft so that the screw (A) is
aligned with the hole in the shaft as shown.
aligned with the hole in the shaft as shown.
•
Tighten screw A.
•
Tighten screw B.
CAUTION! Make sure that the drive shaft inside the shaft
engages with the cut-out in the cutting head.
engages with the cut-out in the cutting head.
Fitting the cutting head
(Saw attachment without shaft PA)
•
Remove the mitre gear from the shaft.
•
Fit the cutting attachment to the shaft.
•
Tighten screw A.
•
Tighten screw B.
CAUTION! Make sure that the drive shaft inside the shaft
engages with the cut-out in the cutting head.
engages with the cut-out in the cutting head.
Fitting the bar and chain
•
Unscrew the bar nut and remove the protective cover.
•
Fit the bar over the bar bolt. Place the bar in its rearmost
position. Place the chain over the drive sprocket and in the
groove on the bar. Begin on the top side of the bar.
position. Place the chain over the drive sprocket and in the
groove on the bar. Begin on the top side of the bar.
•
Make sure that the edges of the cutting links are facing
forward on the top edge of the bar.
forward on the top edge of the bar.
•
Fit the cover and locate the chain adjuster pin (A) in the
hole in the bar. Check that the drive links of the chain fit
correctly on the drive sprocket (B) and that the chain is in
the groove in the bar (C). Tighten the bar nut finger-tight.
hole in the bar. Check that the drive links of the chain fit
correctly on the drive sprocket (B) and that the chain is in
the groove in the bar (C). Tighten the bar nut finger-tight.
•
Tension the chain by turning the chain tensioning screw
clockwise using the combination spanner. The chain
should be tensioned until it does not sag from the
underside of the bar.
clockwise using the combination spanner. The chain
should be tensioned until it does not sag from the
underside of the bar.
•
The chain is correctly tensioned when it does not sag from
the underside of the bar, but can still be turned easily by
hand. Hold up the bar tip and tighten the bar nuts with the
combination spanner.
the underside of the bar, but can still be turned easily by
hand. Hold up the bar tip and tighten the bar nuts with the
combination spanner.
•
When fitting a new chain, the chain tension has to be
checked frequently until the chain is run-in. Check the
chain tension regularly. A correctly tensioned chain
ensures good cutting performance and long life.
checked frequently until the chain is run-in. Check the
chain tension regularly. A correctly tensioned chain
ensures good cutting performance and long life.
Fitting the hanging ring
Fit the hanging ring between the rear handle and the loop
handle. Position the hanging ring so that the machine is
balanced and comfortable to work with.
handle. Position the hanging ring so that the machine is
balanced and comfortable to work with.
A
B
A
B