Festool ETS 153 EQ 用户手册

4

The mains voltage must correspond with the volt-

age on the rating plate! 
See the following fi gure for connection and dis-

connection of the power cable. 

 Always switch the machine off before 

connecting or disconnecting the power cable! 

Switch (2.1) is an on/off switch. For continuous 

use it can be engaged with the lateral locking 

button (2.2). Pressing the switch again releases 

the lock. 

If an extension cord is required, it must have suf-

fi cient cross-section to prevent an excessive drop 

in voltage or overheating. An excessive drop in 

voltage reduces the output and can lead to failure 

of the motor. The table below shows you the cor-

rect cord diameter as a function of the cord length 

for the ETS 150/3 EQ, ETS 150/5 EQ.

Total Extension Cord 

Lenght (feed)

25

50

100 150

Cord size (AWG)

18

16

16

14

Use only U.L. and CSA listed extension cords. 

Never use two extension cords together. Instead, 

use one long one.
Note: The lower the AWG number, the stronger 

the cord.

 Always remove the power plug from 

the socket before carrying out any work on the 

power tool. 

You can regulate the speed steplessly between 

6000 and 10500 rpm using the adjusting wheel 

(2.3). This lets you optimize the sanding speed to 

suit the material (see "Working with the tool"). 

Dust extractors prevent large accumulations of 

dust in the air in the working environment and 

dirt collecting in the workplace.
Inboard extraction 

The machines are fi tted with inbuilt extraction as 

standard. The sanding dust is extracted through 

suction openings in the sanding base (3.4) and 

trapped in the turbo-fi lter (3.2). 
The turbo-fi lter has to be changed when it is so full 

of dust that the extraction power diminishes:
– Push the front cardboard section of the turbo-

fi lter with the sealing lip (3.1) onto the extraction 

nozzle (3.8) of the fi lter holder

– Insert rear cardboard section with slot (3.3) onto 

the retaining strip (3.9) of the fi lter holder

– Push  the  fi lter holder with its opening (3.6) as 

far as it will go onto the extraction nozzle (3.5) 

of the machine and clamp tight by turning rotary 

knob (3.7).

In order to avoid frequent changing of the turbo-

fi lter when carrying longer sanding jobs, it is 

possible to connect a Festool extractor to the unit 

instead of using inbuilt extraction. 
In this case, the extraction pipe (Ø 27 mm) (4.1) 

of the extraction unit is connected to the suction 

nozzle.