Festool PI570789 用户手册

6

 Stickfi x is a hook-and-loop fastening sys-

tem. Stickfi x sanding pads allow the use 

of self-adhesive hook-and-loop abrasives 

such as Stickfi x sandpapers and sanding 

cloths. 

Simply press the abrasive onto the sanding pad 

and pull it off again after use.

 Use only abrasives with an undam-

aged Stickfi x hook-and-loop coating. Before use, 

check that the coating has not been damaged by 

improper use (such as over heating). 

 The Mini-Stickfi x D 52 sanding pad 

was developed for use in confi ned spaces and 

with small areas. This small-diameter pad and 

the affi xed abrasive will inevitably heat up in use 

more than larger pads, since the same pressure 

is distributed over a smaller area. Sand only with 

moderate pressure and do not sand continuously 

for too long. Lift the sander off the workpiece at 

intervals to allow friction heat to dissi-pate.

 Always secure the workpiece in 

such a manner that it cannot move while being 

sanded. 

 Never overload the tool by using 

too much pressure! The best sanding results 

are achieved when applying moderate pressure. 

Sanding performance and quality depend primarily 

on the choice of the right abrasive. 

 For safe guidance, always hold the 

tool with both hands.
We recommend the following settings on the ro-

tary control (2.1) for electronic machines: 
6
• Sanding hard GRP components (limited suit-

ability). 

3 - 6
• Sanding off dry, cracked paint. 
• Stripping anti-fouling paints. 
• Sanding wood. 
2 - 4
• Sanding paint/varnish with tendency to smear 
• Light sanding of thin top coats of paint. 
• Cleaning sandstone, concrete, formwork materi-

als. 

1 - 2
• Sanding thermoplastic materials. 
• Smoothing treated woods with sanding brush. 

 All maintenance or repair work re-

quiring the motor housing to be opened must be 

carried out only by an authorized service work-

shop. Maintenance or repair work carried out by 

an unauthorized person can lead to the incorrect 

connection of the wiring or other components, 

which in turn can lead to accidents with serious 

consequences.

 Always remove the plug from the 

mains supply socket before carrying out any work 

on the machine! 
Always keep the tool and in particular the ventila-

tion slots clean. 
The tool is fi tted with special motor brushes with 

an automatic cut-out. When the brushes become 

worn the power supply is shut off automatically 

and the tool comes to a standstill. 

 For safety reasons, only use original 

Festool accessories and tools!
The accessory and tool order number can be found 

in the Festool catalog or on the Internet under 

www.festool-usa.com.

Many Festool products are shipped in a unique 

system container, called "Systainer". This provides 

protection and storage for the tool and acces-

sories. The Systainers are stackable and can be 

interlocked together. They also can be interlocked 

atop Festool CT dust extractors. 

– Place one systainer on top of the other. 
– Release all four latches on the lower systainer 

by pulling back at their top edges (8.1). 

– Slide all four latches upward (8.2). 
– Snap all four latches back to their fl at position 

(8.3) so they engage the stacking tabs of the 

upper systainer.