Wasp Bar Code WLS 8400 FZ 用户手册

6-15

The data interface consists of an RS-232 port designed to operate either with or without the 
hardware handshaking lines, Request to Send (RTS), and Clear to Send (CTS).

If Standard RTS/CTS handshaking is not selected, scan data is transmitted as it becomes 
available. If Standard RTS/CTS handshaking is selected, scan data is transmitted according 
to the following sequence: 

•

The scanner reads the CTS line for activity. If CTS is de-asserted, the scanner waits 
up to the Host Serial Response Time-out for the host to de-assert the CTS line. If, 
after Host Serial Response Time-out (default), the CTS line is still asserted, the 
scanner sounds a transmit error, and any scanned data is lost.

•

When the CTS line is de-asserted, the scanner asserts the RTS line and waits up to 
the Host Serial Response Time-out for the host to assert CTS. When the host asserts 
CTS, data is transmitted. If, after Host Serial Response Time-out (default), the CTS 
line is still de-asserted, the scanner sounds a transmit error, and discards the data.

•

When data transmission is complete, the scanner de-asserts RTS 10 msec after 
sending the last character.

•

The host should respond by de-asserting CTS. The scanner checks for a de-asserted 
CTS upon the next transmission of data.

During the transmission of data, the CTS line should be asserted. If CTS is de-asserted for 
more than 50 ms between characters, the transmission is aborted, the scanner sounds a 
transmission error, and the data is discarded.

If the above communications sequence fails, the scanner issues an error indication. In this 
case, the data is lost and must be rescanned.

If Hardware Handshaking and Software Handshaking are both enabled, Hardware 
Handshaking takes precedence.

The DTR signal is jumped to the active state.