Wasp Bar Code WLS 8400 FZ 用户手册
User Preferences
4-7
Power Mode
This parameter determines whether or not the scanner enters reduced power mode after a
decode attempt. When in reduced power mode, the scanner draws less current from its
power source.
decode attempt. When in reduced power mode, the scanner draws less current from its
power source.
*Continuous On
Reduced Power Mode
Laser On Time
This parameter sets the maximum time that decode processing continues during a scan
attempt. It is programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default
Laser On Time is 3.0 seconds.
attempt. It is programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default
Laser On Time is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan two numeric bar codes
beginning on page
beginning on page
that correspond to the desired on
time. Single digit numbers must have a leading zero. For example, to set a Laser On Time
of 0.5 seconds, scan the bar code below, then scan the “0” and “5” bar codes. In case of an
error, or to change the selection, scan Cancel on page
of 0.5 seconds, scan the bar code below, then scan the “0” and “5” bar codes. In case of an
error, or to change the selection, scan Cancel on page
.
Laser On Time