Motorola T1/E1 用户手册

Canopy  T1/E1 Multiplexer 

 

 

 

 

 

 

September 2004 

 

 

 

 

 

 

     

      T1/E1 Multiplexer FPGA Version 3.4 

 
 

 

Page 9 of 73 

 

a notice that the risk of harm to equipment or service exists. 

 

 

a notice that the risk of harm to person exists.  

 

Help is available for problems with supported products and features. The sequence of 
actions that you should take if these problems arise is provided under 

 on Page 

We welcome your feedback on Canopy system documentation. This includes feedback 
on the structure, content, accuracy, or completeness of our documents, and any other 
comments you have. Please send your comments to  

This user guide provides the installation and configuration requirements for the Canopy 
T1/E1 Multiplexer, a modular gateway that works with Canopy Backhaul Modules to 
enable up to four T1 (or up to three E1) circuits to be extended over Ethernet networks.   
The Canopy T1/E1 Multiplexer is available in two power configurations: 

◦ 

an external 3.3-v DC power source from a 120/240-v AC adapter (supplied  
by Canopy) 

 

 

WARNING! 

An external AC surge suppression device must be used with the Canopy 
T1/E1 Multiplexer. For infrastructure installations, Canopy Engineering 
recommends an AC line surge suppression unit that meets the standard 
IEC 801-5 (EN61000-4-5) Maximum Surge Voltage (1.2x50µsec) 6 KV.

 

 

◦ 

a connection to an external 

−48 v DC supply. 

The Canopy T1/E1 Multiplexer is illustrated with Canopy Backhaul Modules (BHs) in 

Issue 3