Sony 8000SF 用户手册
440
Basic Procedure for Wipe Settings
C
• When a diamond dust wipe is selected (pattern number 274)
Note
When Flash Rate is set to 0.00, you cannot change the pattern. In this state,
adjusting H Size or V Size has no effect on the pattern.
adjusting H Size or V Size has no effect on the pattern.
For details of a pattern mix, see the next section.
For details of applying pattern modifiers, see “Setting Wipe Modifiers”
(page 443).
For details of applying pattern modifiers, see “Setting Wipe Modifiers”
(page 443).
Selecting a wipe pattern in the Flexi Pad control block
To select a pattern with a standard type Flexi Pad control block, use the
following procedure. (It is not possible to select a wipe pattern with a simple
type Flexi Pad control block.)
following procedure. (It is not possible to select a wipe pattern with a simple
type Flexi Pad control block.)
1
In the M/E-1 Flexi Pad control block, press the [WIPE] button.
This switches the Flexi Pad control block to wipe snapshot mode.
2
In the memory recall section, press the [PTN NO] button.
2
V Size
Tile height
0.00 to 100.00
3
Volatility
Rate of tile generation
0.00 to 100.00
Knob
Parameter
Adjustment
Setting values
Knob
Parameter
Adjustment
Setting values
1
H Size
Particle width
0.00 to 100.00
2
V Size
Particle height
0.00 to 100.00
3
Flash Rate
Rate of generation of particles
0.00 to 100.00