National Instruments NI PCIe-836x 用户手册

© National Instruments Corporation

This chapter explains how to install the MXI-Express hardware.

The following are general instructions for installing the MXI-Express 
cards. Consult your computer user manual or technical reference manual 
for specific instructions and warnings.

The software for your MXI-Express kit is included with the current NI driver CD, 

and is installed with the PXI platform software included as part of NI-VISA and other 
NI driver software products.

1.

Power off your computer, but leave it plugged in while installing the 
NI PCIe-836x. The power cord grounds the chassis and protects it from 
electrical damage while you install the card.

To protect both yourself and the computer from electrical hazards, your computer 

should remain off until you finish installing the NI PCIe-836x.

If you are installing a low-profile PCIe-8361 into a low-profile slot, you must 

replace the bracket with the low-profile bracket included in your kit. First, remove the 
two hexagonal jack screws on either side of the connector. Then remove the two screws 
mounting the bracket to the card. Exchange the brackets, replace the two mounting screws, 
and replace the two hexagonal jack screws.

2.

Remove the top cover or access port to the PCI Express bus.

3.

Select any available PCI Express expansion slot (x1 or wider).

The BIOS or motherboard may not support the NI PCIe-836x in a slot intended for 

a graphics card.