Avaya P460 用户手册
Chapter 5
Avaya P460 Layer 3 Features
Avaya P460 Configuration Guide
43
Basic Router Configuration
L You need to install the Layer 3 license before you can configure Layer 3
parameters.
The following example shows configuration of a basic IP interface and the routing
protocol over this interface. It is not intended to provide comprehensive
configuration information.
The example shows the following steps:
•
protocol over this interface. It is not intended to provide comprehensive
configuration information.
The example shows the following steps:
•
Entering router mode
•
Configuring a VLAN for a specific interface
•
Enabling the required protocol
1
Enter Router mode:
L Changing the device mode requires a switch reset.
2
Use the session command to switch to the router entity:
Create a router Layer 2 interface
Specify the VLAN on which an IP
interface resides
interface resides
Display information about the IP
unicast routing table
unicast routing table
Display information for an IP
interface
interface
Display the status of ICMP error
messages
messages
P460-1(super)# set device-mode router
P460-1(super)# session router
Router-1(super)#
In order to...
Use the following command...