Raritan Engineering KX2-832 用户手册

Chapter 7: Device Management 
 

3.  On the Port Configuration page, click on the name of the blade 

chassis you want to configure. The Port page will open. 

4.  Select the Blade Chassis radio button. The page will then display the 

necessary fields to configure a blade chassis. 

5.  Select the Dell blade chassis model from the Blade Server Chassis 

Model drop-down.   

 

1.  If you selected Dell PowerEdge M1000e, auto-discovery is available. 

Configure the blade chassis as applicable. Prior to configuring a 
blade chassis that can be auto-discovered, it must be configured to 
enable SSH connections on the designated port number (see 

 (on page 125)). Additionally, a user account with the 

corresponding authentication credentials must be previously created 
on the blade chassis. 

a.  Switch Hot Key Sequence - Select the hot key sequence that will 

be used to switch from KVM to the blade server. The Switch Hot 
Key Sequence must match the sequence used by the KVM 
module in the blade chassis. 

b.  Maximum Number of Slots - The default maximum number of 

slots available on the blade chassis is automatically entered. 

c.  Administrative Module Primary IP Address/Host Name - Enter 

the primary IP address for the blade chassis. Required for 
auto-discovery mode 

d.  Port Number - The default port number for the blade chassis is 

22. Change the port number if applicable. Required for 
auto-discovery mode 

e.  Username - Enter the username used to access the blade 

chassis. Required for auto-discovery mode 

f. 

Password - Enter the password used to access the blade 
chassis. Required for auto-discovery mode 

2.  If you want the Dominion KX II to auto-discover the chassis blades, 

select the Blade Auto-Discovery checkbox and then click the 
Discover Blades on Chassis Now button. Once the blades are 
discovered, they will be displayed on the page.   

3.  Change the blade chassis name if needed. If the chassis is already 

named, that information automatically populates this field. If it is not 
already named, the Dominion KX II assigns the chassis a name. The 
default naming convention for the blade chassis by the Dominion KX 
II is # Blade_Chassis_Port#. 

4.  If operating in Manual mode, indicate the blades that are installed in 

the blade chassis by checking the Installed checkbox next to each 
slot that has a blade installed. Alternatively, use the Select All 
checkbox. If needed, change the blade server names