Raritan Engineering KX2-832 用户手册
Chapter 12: Command Line Interface (CLI)
216
Setting Network Parameters
Network parameters are configured using the interface command.
admin > Config > Network > interface enable true if lan1
ip 192.16.151.12 mask 255.255.255 gw 192.168.51.12
ip 192.16.151.12 mask 255.255.255 gw 192.168.51.12
When the command is accepted, the device automatically drops the
connection. You must reconnect to the device using the new IP address
and the user name and password you created in the resetting factory
default password section.
connection. You must reconnect to the device using the new IP address
and the user name and password you created in the resetting factory
default password section.
Important: If the password is forgotten, the Dominion KX II will need
to be reset to the factory default from the Reset button on the back
of the Dominion KX II. The initial configuration tasks will need to be
performed again if this is done.
to be reset to the factory default from the Reset button on the back
of the Dominion KX II. The initial configuration tasks will need to be
performed again if this is done.
The Dominion KX II now has the basic configuration and can be
accessed remotely via SSH, GUI, or locally using the local serial port.
The administrator needs to configure the users and groups, services,
security, and serial ports to which the serial targets are attached to the
Dominion KX II.
accessed remotely via SSH, GUI, or locally using the local serial port.
The administrator needs to configure the users and groups, services,
security, and serial ports to which the serial targets are attached to the
Dominion KX II.
Note: Both IPv4 and IPv6 addresses are supported.
CLI Prompts
The Command Line Interface prompt indicates the current command
level. The root portion of the prompt is the login name. For a direct admin
serial port connection with a terminal emulation application, Admin Port
is the root portion of a command.
level. The root portion of the prompt is the login name. For a direct admin
serial port connection with a terminal emulation application, Admin Port
is the root portion of a command.
admin >
For TELNET/SSH, admin is the root portion of the command:
admin > config > network >
0
CLI Commands
•
Enter admin > help.
Command
Description
config
Change to config sub menu.
diagnostics
Change to diag sub menu.
help
Display overview of commands.