Cabletron Systems STHI 用户手册

Page 5-1

This chapter explains how to set up a console to access the STHI’s Local 
Management interface (LM) and explains how to use LM screens and 
commands.

LM enables the user to perform the following actions on the STHI and all 
of its attached segments:

•

assign an IP address and subnet mask to the STHI;

•

select a default gateway for the transmission of SNMP traps;

•

configure, enable, and disable ports throughout the stack;

•

control access to the STHI through community names;

•

designate which Network Management Stations (NMS) are to receive 
trap messages from the device;

•

access and manipulate the Management Information Base (MIB);

•

and view statistics regarding errors, beacons, and traffic for the entire 
stack, individual module, or individual port.

To access LM, the user needs the following equipment:

•

an actual or emulated Digital Equipment Corporation VT series 
terminal.

•

a console cable to attach the management terminal to the STHI. Refer 
to Section 2.2.2, TCU and COM Ports for pinout information.