Seiko Instruments DPU-30 用户手册

 

3.3 INSTALLATION 
 

1.  How to Install the Fixing Bracket 

 
 

スペー サー を必要 なぶ ん重ね て使 用す る。

 

 

∗ Use the spacers depending on the fitting panel thickness referring to the next table. If not, 

the body may be deformed, and therefore it may be hard to open the paper cover or printing 
quality may be deteriorated. (If the fitting panel thickness exceeds 2.2 mm, it may be hard to 
tighten the screws.) 

 

 

 

1.0 mm 

None 

1.7 to 1.8 mm 

0.5 mm and 0.2 mm 

1.2 mm 

0.2 mm 

2.0 mm 

1.0 mm 

1.5 to 1.6 mm 

0.5 mm 

2.2 mm 

1.0 mm and 0.2 mm 

 

∗ The screw torque is 49 cN m (5 kgf cm). 

 

[Note] Do not touch the end of the DC plug. 

 
 

2. Setting 

Paper 

 

(1)  Press the paper cover open button, and open the paper cover. 

 

 

Handle the paper cutter carefully not to cut your hand.

 

 

(2)  Set a paper roll as shown in the figure.

 

 

(3)  Close the paper cover by pressing both ends of the cover so the tip end of the paper will 

be emerged from the printer.

 

Use the spacers as much as you need