Epson LQ-1170 用户手册

Press this button to load paper, if it is not loaded, or to eject it if

paper is loaded. If the paper-release lever is set to the single-sheet

position, paper is ejected forward. If the paper-release lever is set to

the front-tractor or rear-tractor position, paper is ejected backward to

Press this button briefly to feed the paper forward one line. Hold

down this button to eject a single sheet of paper or advance

continuous paper to the top of the next page.

The indicator lights give you the current status of the printer. The

buttons let you control many of the printer settings.

Holding down this button while pressing certain other buttons

results in the following alternate functions:

BUFFER CLEAR

clears the printer’s buffer and

 the printer settings

Lights

(green)

On when the power switch is on and power is supplied.

On when data is present in the printer’s memory buffer.

(green)

 when the paper-thickness lever is set to 2nd position or higher.

(red)

 when the printer runs out of paper.

press the PAUSE button. This light stays off unless you

press the PAUSE button to prevent printing.

(orange)

On when you press the TEAR OFF button to feed the paper to the 

off position.

(green)

 when bin 1 of the optional cut-sheet feeder is selected for paper

feeding.
BIN 2 (green)

On when bin 2 of the optional cut-sheet feeder is selected for paper

feeding.
Fonts 

Show which font is selected.

which pitch is selected.

Press this button to temporarily stop printing. 

again

to resume printing.

feeds paper forward in

 increments

feed paper backward in 

increments

Select)

This button selects the paper bin when both optional cut-sheet

feeders are installed and you are printing on single sheets. When

printing on continuous paper, press this button once to feed paper

from the loading position to the tear-off position. Press this button

again to feed the paper backward to the loading position.

Press this button to select one of the 10 built-in fonts.   an optional

font module has been installed, it can be selected by choosing SLOT.

Press this button to select one of the six character pitches (characters

per inch).
The control panel also gives you access to two special functions.

Data dump:

Hold down the 

 mode) or LOAD/EJECT (Draft

mode) button while turning on the printer to perform

the self test. The self test lets you check that your

printer is operating properly and gives you a printout

of the current DIP-switch settings.
Hold down both the 

button and LOAD/EJECT

button while turning on the printer to enter data-dump

mode. The data-dump mode allows advanced users to

find the cause of communication problems between the

printer and the computer.