Xerox 721P90350 用户手册
Setting up workstations
Guide to Submitting Jobs from the Client
2-7
NOTE: If the wrong software has been loaded on the client, the
executable files may have the wrong extension. If this is the case,
delete everything under the above directories.
executable files may have the wrong extension. If this is the case,
delete everything under the above directories.
If there are any files named print, listq, or listjob in the
directories, /bin, or /usr/bin, delete them also.
directories, /bin, or /usr/bin, delete them also.
Make sure that the DOS print command is not accidentally
removed instead of the DocuPrint NPS/IPS print command. If
you are not sure which command it is, type print <Enter>. The
NPS/IPS command will always give a usage statement.
removed instead of the DocuPrint NPS/IPS print command. If
you are not sure which command it is, type print <Enter>. The
NPS/IPS command will always give a usage statement.
Setting up Macintosh workstations
This section describes the steps for installing the Xerox
Document Submission Client Software.
Document Submission Client Software.
Preparing for installation
Before installing the software, make sure your computer has the
following hardware and software:
following hardware and software:
•
2 MB of Random Access Memory (RAM)
•
A properly configured network card, or a bridge from
LocalTalk to the network
LocalTalk to the network
•
A 3.5-inch, 1.4-MB diskette drive
•
A hard drive
•
AppleShare version 2.0 or above
•
System 8.6 or greater
•
EtherTalk, version 1.0 or above
•
Ethernet software that is associated with your Ethernet card
•
Apple LaserWriter Driver, version 7.11 or higher. Version 8.0
or higher is recommended for use with PPD files, since
earlier versions do not recognize PPD files.
or higher is recommended for use with PPD files, since
earlier versions do not recognize PPD files.
NOTE: You cannot run the print job submission utility if you have
the QuickDraw GX environment installed.
the QuickDraw GX environment installed.