Xerox 180 EPS 用户手册

The Online Gateway was unable to recover 

the current job due to an internal error.

Job <job ID> aborted.

Select Reset to clear fault.

This message displays when the Online gateway encounters an 
internal error during a crash recovery and the system aborts the 
job. The job status shows the state of the job. If the job specifies 
an accounting page, the page is generated. The accounting log 
displays the Job Aborted status.

Job <job ID>: LCDS Decomposer could not 

recover data.  Job will be ended 

prematurely.

Job <job ID>: LCDS Decomposer could not 

recover data.  Job will be ended 

prematurely.

This message is displayed when the LCDS Decomposer 
encounters an internal error during recovery. Upon clicking 
Continue in the Printer Fault Clearance window, the job is aborted. 
The job status shows the Job Aborted state. No accounting page 
is generated.

In Spooling mode, a job does not print until all its data is received.

If the system crashes after spooling all the data, follow the 
directions for Streaming mode. If the system crashes while 
receiving data, the job is aborted.

After a crash, wait until the system is idle before restarting. Wait 
for the printer engine to cycle down and make sure that the Job 
Manager shows no changes in the job state. 

•

If automatic recovery is possible and the same system fault 
occurs twice within the report, the system prints any formatted 
reports, but aborts the current job. If there are system faults 
that do not result in restarting the system, the system does not 
print the reports.

Automatic recovery refers to restarting of the system software 
following a system fault such as when a critical component 
dies.

•

You may change the buffer size that determines how many