Xerox FS 3270 用户手册

7.  Power the Xerox FS 3270 OFF and back ON and check that all

indicators light up momentarily. (The indicators are describ ed in
Section 3.1, Indicator LEDs).

8.  Proceed to section 2.3  Connecting Xerox FS 3270  to the System.

2.4. Connecting the   Xerox FS 3270   to the System

After a successful test printout has been generated to ensure that the
connection between the Xerox FS 3270  converter and the printer is
working correctly (see previous section), you are now ready to connect
the Xerox FS 3270  to the system.

All connections to the   Xerox FS 3270  protocol con 

1.  Turn off the power and connect the Xerox FS 3270  to your host

system using the coax cable.

2. When the connection has been made, turn power ON and check that

the CU and READY indicators turn ON. When it does, you have
completed the installation procedure and are ready to operate the
protocol converter as described below.

If the CU indicator does not turn ON, this means that there is no
communication with the control unit. You should check the follow ing:

a. The coax cable connection from the control unit to the Xerox FS

b.  The control unit (is it powered up etc.)

c.  Is the control unit supported by the Xerox FS 3270  (See Section

1.3, Supported Control Units, for a list of sup ported control
units).