EIKI LC-SD10 用户手册
12
This projector uses nominal input voltages of 100-120 V or 200-240
V AC. This projector automatically selects the correct input
voltage. It is designed to work with single-phase power systems
having a grounded neutral conductor. To reduce risk of electrical
shock, do not plug into any other type of power system.
Consult your authorized dealer or service station if you are not sure
of the type of power supply being in use.
Connect a projector with a peripheral equipment before turning a
projector on. (Refer to page 15 –16 for connection.)
V AC. This projector automatically selects the correct input
voltage. It is designed to work with single-phase power systems
having a grounded neutral conductor. To reduce risk of electrical
shock, do not plug into any other type of power system.
Consult your authorized dealer or service station if you are not sure
of the type of power supply being in use.
Connect a projector with a peripheral equipment before turning a
projector on. (Refer to page 15 –16 for connection.)
CAUTION
For safety, unplug the AC Power Cord when an appliance is not used.
When this projector is connected to the outlet with the AC Power Cord,
an appliance is in Stand-by Mode and consumes a little electric power.
When this projector is connected to the outlet with the AC Power Cord,
an appliance is in Stand-by Mode and consumes a little electric power.
Connect AC Power Cord (supplied) to the
projector. The AC outlet must be near this
equipment and must be easily accessible.
projector. The AC outlet must be near this
equipment and must be easily accessible.
Note:
AC Power Cord must meet requirement of the country where you use the projector.
Confirm an AC plug type with the chart below and proper AC Power Cord must be used.
If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.
Confirm an AC plug type with the chart below and proper AC Power Cord must be used.
If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.
To POWER CORD
CONNECTOR on your
projector.
CONNECTOR on your
projector.
Projector side
AC Outlet side
Ground
To the AC Outlet.
(120 V AC)
For Continental Europe
For the U.S.A. and Canada
To the AC Outlet.
(200 - 240 V AC)
Connecting the AC Power Cord
Preparation