Benq MS517 用户手册

下载
页码 74
Operation
44
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The 
following settings do not affect the projection settings, operation, or performance. 
• Menu display Time in the SYSTEM SETUP: Basic Menu Settings menu sets 
the length of time the OSD will remain active after your last key press. The time length 
ranges from 5 to 30 seconds in 5-second increments. Use 
/
 to select a suitable 
time frame.
• Menu Position in the SYSTEM SETUP: Basic > Menu Settings menu sets the 
OSD position in five locations. Use 
/
 to select a preferred position.
• Language in the SYSTEM SETUP: Basic menu sets your familiar language for the 
OSD menus. Use Enter to select your language. 
• Reminder Message in the SYSTEM SETUP: Basic > Menu Settings menu sets 
whether to display reminder messages on screen. Use 
/
 to select your desired 
setting.
• Splash Screen in the SYSTEM SETUP: Basic menu sets a preferred logo screen 
to be displayed during projector start-up. Use 
/
 to select a screen.
Select the lamp saver mode
• Using the remote control. 
Press SmartEco and Highlight Lamp Mode and press 
/
 to select Normal/
Economic/SmartEco.
• Using  the  OSD  menu.
1.
Press Menu/Exit and then press 
/
 
until the SYSTEM SETUP: Advanced 
menu is highlighted.
2.
Press  
to 
highlight 
Lamp Mode and press 
Mode/Enter. The Lamp Settings page 
displays.
3.
Highlight Lamp Mode and press 
/
 to 
select Normal/Economic/SmartEco. The lamp brightness vary from the different 
lamp mode,see the description list in table below.
If the Economic mode or SmatEco mode is selected, the light output will be reduced and result 
in darker projected pictures.
Lamp Mode
Description
Normal
100% lamp brightness
.
Economic
Saves 20% lamp power consumption.
SmartEco
Saves up to 70% lamp power consumption depending on the content 
brightness level.